Instructions for Fixing Errors F10 Error Code Kenmore Oven

Introduction

The F10 error code on a Kenmore oven indicates a problem with the oven’s temperature sensor. This error code can be frustrating, especially if you’re in the middle of cooking a meal. However, with a few simple steps, you can fix the F10 error code and get your oven back to working order.

Step 1: Turn Off the Power

Before you begin any repairs on your Kenmore oven, it’s important to turn off the power. This will ensure your safety and prevent any electrical shocks. To turn off the power, locate the circuit breaker that controls your oven and switch it off.

Step 2: Check the Temperature Sensor

The F10 error code is often caused by a faulty temperature sensor. To check the temperature sensor, you’ll need to remove the back panel of your oven. Once the panel is removed, locate the temperature sensor and check for any signs of damage or wear. If the temperature sensor is damaged, you’ll need to replace it.

Replacing the Temperature Sensor

To replace the temperature sensor, follow these steps:

1. Disconnect the wires from the old temperature sensor.
2. Remove the screws that hold the temperature sensor in place.
3. Install the new temperature sensor and secure it with screws.
4. Reconnect the wires to the new temperature sensor.

Step 3: Check the Wiring

If the temperature sensor is not the problem, the F10 error code may be caused by faulty wiring. To check the wiring, you’ll need to remove the back panel of your oven and inspect the wiring for any signs of damage or wear. If you find any damaged wiring, you’ll need to replace it.

Replacing the Wiring

To replace the wiring, follow these steps:

1. Disconnect the wires from the damaged wiring.
2. Remove the screws that hold the damaged wiring in place.
3. Install the new wiring and secure it with screws.
4. Reconnect the wires to the new wiring.

Step 4: Check the Control Board

If the temperature sensor and wiring are not the problem, the F10 error code may be caused by a faulty control board. To check the control board, you’ll need to remove the back panel of your oven and inspect the control board for any signs of damage or wear. If you find any damaged components on the control board, you’ll need to replace it.

Replacing the Control Board

To replace the control board, follow these steps:

1. Disconnect the wires from the old control board.
2. Remove the screws that hold the control board in place.
3. Install the new control board and secure it with screws.
4. Reconnect the wires to the new control board.

Step 5: Test the Oven

Once you’ve completed the repairs, it’s important to test your oven to ensure it’s working properly. Turn on the power and set the oven to a desired temperature. Wait for the oven to reach the set temperature and check for any error codes. If the oven is working properly, you should not see the F10 error code.

Conclusion

Fixing the F10 error code on your Kenmore oven may seem daunting, but with these simple steps, you can get your oven back to working order. Remember to always turn off the power before beginning any repairs and to test your oven once the repairs are complete. If you’re unsure about any of the steps, it’s always best to consult a professional.

With the above information sharing about f10 error code kenmore oven on official and highly reliable information sites will help you get more information.