Instructions for Fixing Errors F2 Error Code GE Oven

Introduction

GE ovens are known for their durability and reliability. However, like any other appliance, they are prone to errors and malfunctions. One of the most common errors that GE oven users encounter is the F2 error code. This error code indicates that there is a problem with the oven’s temperature sensor or the oven control board. In this article, we will provide you with step-by-step instructions on how to fix the F2 error code on your GE oven.

Step 1: Turn off the Power

Before you start fixing the F2 error code on your GE oven, you need to turn off the power. This is important to ensure your safety and prevent any electrical accidents. To turn off the power, locate the circuit breaker that controls your oven and switch it off. Alternatively, you can unplug the oven from the power source.

Step 2: Check the Temperature Sensor

The temperature sensor is responsible for monitoring the oven’s temperature and sending signals to the oven control board. If the temperature sensor is faulty, it can cause the F2 error code to appear on your GE oven. To check the temperature sensor, follow these steps:

Step 2.1: Locate the Temperature Sensor

The temperature sensor is usually located at the back of the oven. You can access it by removing the back panel of the oven.

Step 2.2: Check the Resistance

Using a multimeter, check the resistance of the temperature sensor. The resistance should be between 1000 and 1100 ohms at room temperature. If the resistance is outside this range, the temperature sensor is faulty and needs to be replaced.

Step 2.3: Replace the Temperature Sensor

If the temperature sensor is faulty, you need to replace it. To do this, disconnect the wires that are connected to the temperature sensor and remove it from the oven. Install the new temperature sensor and reconnect the wires.

Step 3: Check the Oven Control Board

If the temperature sensor is not the problem, the F2 error code may be caused by a faulty oven control board. To check the oven control board, follow these steps:

Step 3.1: Locate the Oven Control Board

The oven control board is usually located behind the control panel of the oven. You can access it by removing the screws that hold the control panel in place.

Step 3.2: Check for Burnt Components

Inspect the oven control board for any burnt components or damaged circuits. If you find any, the oven control board is faulty and needs to be replaced.

Step 3.3: Replace the Oven Control Board

If the oven control board is faulty, you need to replace it. To do this, disconnect the wires that are connected to the oven control board and remove it from the oven. Install the new oven control board and reconnect the wires.

Step 4: Test the Oven

After replacing the temperature sensor or the oven control board, you need to test the oven to ensure that the F2 error code is no longer appearing. To do this, turn on the power and set the oven to a temperature of 350 degrees Fahrenheit. Wait for the oven to reach the set temperature and check if the F2 error code appears. If it does not, your GE oven is now working properly.

Conclusion

The F2 error code on your GE oven can be frustrating, but it is not a difficult problem to fix. By following the steps outlined in this article, you can easily diagnose and fix the problem. Remember to always turn off the power before working on your oven and to seek professional help if you are not comfortable with DIY repairs.

With the above information sharing about f2 error code ge oven on official and highly reliable information sites will help you get more information.