Instructions for Fixing Errors F2 Error Code Whirlpool Oven

Introduction

Whirlpool ovens are known for their durability and reliability. However, like any other appliance, they can develop faults over time. One of the most common errors that Whirlpool oven users encounter is the F2 error code. This error code indicates that there is a problem with the oven’s temperature sensor or the control board. In this article, we will provide you with step-by-step instructions on how to fix the F2 error code on your Whirlpool oven.

Step 1: Turn off the Power

Before you start fixing the F2 error code, you need to turn off the power to your Whirlpool oven. This is important to prevent any electrical accidents. You can turn off the power by unplugging the oven from the wall socket or by turning off the circuit breaker that supplies power to the oven.

Step 2: Check the Temperature Sensor

The temperature sensor is responsible for monitoring the oven’s temperature and sending signals to the control board. If the temperature sensor is faulty, it can cause the F2 error code to appear on the oven’s display. To check the temperature sensor, follow these steps:

Step 2.1: Locate the Temperature Sensor

The temperature sensor is usually located at the back of the oven. You may need to remove the back panel to access it.

Step 2.2: Check the Resistance

Using a multimeter, check the resistance of the temperature sensor. The resistance should be between 1000 and 1100 ohms at room temperature. If the resistance is outside this range, the temperature sensor is faulty and needs to be replaced.

Step 2.3: Replace the Temperature Sensor

If the temperature sensor is faulty, you need to replace it. You can order a replacement temperature sensor from Whirlpool or from a third-party supplier. To replace the temperature sensor, follow these steps:

1. Turn off the power to the oven.
2. Remove the back panel of the oven.
3. Disconnect the wires from the faulty temperature sensor.
4. Remove the faulty temperature sensor from the oven.
5. Install the new temperature sensor in the same position as the old one.
6. Reconnect the wires to the new temperature sensor.
7. Replace the back panel of the oven.
8. Turn on the power to the oven and test it.

Step 3: Check the Control Board

If the temperature sensor is not faulty, the F2 error code may be caused by a faulty control board. To check the control board, follow these steps:

Step 3.1: Locate the Control Board

The control board is usually located behind the control panel of the oven. You may need to remove the control panel to access it.

Step 3.2: Check for Burnt Components

Inspect the control board for any burnt components or damaged wiring. If you find any burnt components or damaged wiring, the control board is faulty and needs to be replaced.

Step 3.3: Replace the Control Board

If the control board is faulty, you need to replace it. You can order a replacement control board from Whirlpool or from a third-party supplier. To replace the control board, follow these steps:

1. Turn off the power to the oven.
2. Remove the control panel of the oven.
3. Disconnect the wires from the faulty control board.
4. Remove the faulty control board from the oven.
5. Install the new control board in the same position as the old one.
6. Reconnect the wires to the new control board.
7. Replace the control panel of the oven.
8. Turn on the power to the oven and test it.

Conclusion

Fixing the F2 error code on your Whirlpool oven is not a difficult task. By following the steps outlined in this article, you can easily diagnose and fix the problem. Remember to turn off the power to the oven before you start working on it, and always follow the manufacturer’s instructions when replacing any parts. If you are not comfortable working on your oven, it is always best to seek the help of a professional technician.

With the above information sharing about f2 error code whirlpool oven on official and highly reliable information sites will help you get more information.