Instructions for Fixing Errors: State Select Water Heater Error Codes

Introduction

State Select water heaters are known for their durability and efficiency. However, like any other appliance, they can experience errors that need to be fixed. These errors can be caused by various factors, including faulty parts, incorrect installation, or lack of maintenance. In this article, we will discuss the most common State Select water heater error codes and provide instructions on how to fix them.

State Select Water Heater Error Codes

Error Code 1

Error code 1 indicates a problem with the ignition system. This error is usually caused by a faulty igniter or a clogged burner. To fix this error, follow these steps:

1. Turn off the power supply to the water heater.
2. Remove the burner assembly and clean it thoroughly.
3. Check the igniter for any damage or wear and tear. If it is damaged, replace it with a new one.
4. Reassemble the burner assembly and turn on the power supply to the water heater.
5. If the error persists, contact a professional plumber for further assistance.

Error Code 2

Error code 2 indicates a problem with the temperature sensor. This error is usually caused by a faulty sensor or a loose connection. To fix this error, follow these steps:

1. Turn off the power supply to the water heater.
2. Locate the temperature sensor and check for any loose connections. If there are any, tighten them.
3. If the connections are tight, check the sensor for any damage or wear and tear. If it is damaged, replace it with a new one.
4. Turn on the power supply to the water heater and check if the error has been resolved.
5. If the error persists, contact a professional plumber for further assistance.

Error Code 3

Error code 3 indicates a problem with the pressure switch. This error is usually caused by a clogged or faulty switch. To fix this error, follow these steps:

1. Turn off the power supply to the water heater.
2. Locate the pressure switch and check for any clogs or blockages. If there are any, clean them.
3. If the switch is still not functioning properly, replace it with a new one.
4. Turn on the power supply to the water heater and check if the error has been resolved.
5. If the error persists, contact a professional plumber for further assistance.

Error Code 4

Error code 4 indicates a problem with the flammable vapor sensor. This error is usually caused by a faulty sensor or a loose connection. To fix this error, follow these steps:

1. Turn off the power supply to the water heater.
2. Locate the flammable vapor sensor and check for any loose connections. If there are any, tighten them.
3. If the connections are tight, check the sensor for any damage or wear and tear. If it is damaged, replace it with a new one.
4. Turn on the power supply to the water heater and check if the error has been resolved.
5. If the error persists, contact a professional plumber for further assistance.

Conclusion

State Select water heaters are reliable appliances that can provide hot water for years. However, errors can occur, and it is important to know how to fix them. By following the instructions provided in this article, you can fix the most common State Select water heater error codes. If you are unsure about any of the steps or if the error persists, contact a professional plumber for further assistance.

With the above information sharing about state select water heater error codes on official and highly reliable information sites will help you get more information.